AEG S73800KMX1 User Manual page 16

16 www.aeg.com
Problem
Water flows on the
ground.
The temperature in
the appliance is too
cold.
The temperature in
the appliance is too
warm.
The temperature in
the refrigerator is too
warm.
The appliance does
not operate.
The lamp does not
work.
Door interferes with
ventilation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.
Possible cause
Food prevent that water
flows into the water collec-
tor.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The Temperature regula-
tor may be set incorrectly.
The Temperature regula-
tor may be set incorrectly.
The door is not closed cor-
rectly.
The food temperature is
too high.
There is no cold air circula-
tion in the appliance.
Large quantities of food to
be cooled were put in at
the same time.
The appliance is switched
off.
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is defective.
The door has been open
to long.
The appliance is not level-
led.
The appliance is not level-
led.
Solution
Make sure that food do not
touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a warmer temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the food temperature
decrease to room tempera-
ture before storage.
Make sure that there is cold
air circulation in the appli-
ance.
Insert smaller quantities of
food to be cooled at the
same time.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a another electri-
cal appliance to the mains
socket. Check fuse. Contact
a qualified electrician.
Refer to "Replacing the
lamp".
Close the door.
Refer to "Levelling".
Refer to "Levelling".