Switching Off The Appliance - AEG ARCTIS User Manual

Built-in freezer
Table of Contents

Advertisement

Setting „4" means:
lowest, coldest internal temperature
Recommended regulator setting:
„2-3".
1. Plug the mains plug into the mains socket.
2. Turn the temperature regulator (B) in the direction of „O"; a sound is
on only for 2 sec. The compressor starts and then runs automatically.
3 .The red lamp (E) flashed and the sound alarm signal. Reset the sound
alarm signal pushing the switch (D) . The red switch continuosly flas-
hes. Operate the fast-freeze switch (D) once again. The yellow pilot
lamp (C) comes on.
4. Only when the red light (E) has gone out should you reset the fast-fre-
eze switch (D). The yellow light (C) goes out and the audible warning
mode is activated again.
The temperature regulator (B) can be used to set the required storage
temperature, -18°C or colder.
Important! Wait until the freezer compartment has reached a tempe-
rature of –18°C, or the red warning light has gone out, before storing
frozen food.
Important: Regularly check on the red temperature pilot light (E) and
the thermometer that the required storage temperature is being main-
tained.

Switching off the appliance

To switch off the appliance, turn the thermostat control knob to posi-
tion "0" .
If the appliance is not going to be used for an extended period:
1. Remove all deep-frozen packages as well as ice-trays.
2. Switch off the appliance by turning the temperature regulator to posi-
tion "0" .
3. Remove the mains plug or switch off or disconnect from the electricity
supply.
4. Defrost freezer and clean thoroughly (see sections: "Defrosting" and
"Cleaning and Care").
5. Leave the door open to avoid the build up of odours.
33

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents