Section 7: Installing And Removing The Door - Montigo L38DF Installation & Maintenance Manual

L38DF* Indoor Gas Fireplace
Section 7: Installing & Removing the Door
Removing the door:
The L38DF* door is removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch the
door buckles and, remove the door. Replace in reverse order.
Step 1:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away from
you and lifting out. Place it aside
during maintenance or cleaning.
Install in reverse order.
Figure 24. Removing and installing the Horizontal Access Panel
Step 2: Locate the Door Buckles.
Figure 24a. Door buckle locations.
Step 3:
Locate Door Buckle Tool.
Hand-hold
Figure 24b. Door buckle Tool
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 24c.
Page 22
Installation
Finger Holes
Installed Gas
Valve Cove r
Door Latch Slot
Door Latch Hook
1
Step 5:
Ensure the tool is firmly in
the lower end of the slot,
(as shown), Then pull toward
you (Caution: hold the tool
securely).
Figure 24d.
Step 6:
Pull hard if necessary to
release the spring tension.
(Caution: The latch springs
back with force, hold the tool
securely).
Figure 24e.
Step 7:
Remove the tool from the
latch slot. Ensure the latches
are hanging freely, the hook
end is released from the
bottom of the door. (Repeat
all 4-steps for the remaining
latches).
Figure 24f.
Step 8:
Removing the Door:
Grasp the Door on either side, usually midway and lift upward, lift
the door carefully up and away from the front of the fireplace. See
Figures 24g. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
Figure 24g. Removing and installing the glass doors.
Installing the Door:
To install the door, hook the top edge of the door frame into place. Lower
the door into position and follow the previous steps shown in reverse order.
2
3
4
XG0180 - 053111.1