Fitting the Hob into the worktop
Carry out the building in of the hob as follows:
•
put the seals
supplied with the hob, on the
edges of the cut out: place
them exactly on the
front edge, at 10 mm from
the rear edge and at 50 mm
from the side edges, as
shown in the diagram,
taking care that the seals
meet without overlapping;
• place the hob in the cut
out, taking care that it is
centred;
• fix the hob with the
relevant fixing clamps and
screws, as shown in the
diagram.
When the screws have been tightened, the excess seal can be removed.
The edge of the hob forms a double seal which prevents the ingress of liquids.
16
FO 2753
FO 0199
Seal