Yamaha RX-V663 Owner's Manual page 99

See page 95 for the operation of the advanced setup.
■ Bi-amplifier setting BI-AMP
Use this feature to activate or deactivate the bi-amplifier
function (see page 16).
Choices: ON, OFF
• Select "ON" if you want to activate the bi-amplifier
function. "SUR.B L/R SP" is set to "NONE"
automatically, and this unit outputs the front channel
audio signals at the SURROUND BACK/BI-AMP
speaker terminals.
• Select "OFF" if you want to deactivate the bi-amplifier
function.
Note
When "BI-AMP" is set to "ON", you can only select
"FRONT B", "ZONE B", or "NONE" in "EXTRA SP ASSIGN"
(see page 73).
■ SCENE IR code setting
Use this feature to output the remote control signals at the
REMOTE OUT jack automatically when this unit is in the
SCENE mode.
Choices: ON, OFF
• Select "ON" when the component connected to the
REMOTE OUT jack is the Yamaha component and has
the capability of the SCENE control signals. This unit
automatically sends the remote control signals to the
component.
• Select "OFF" when the component connected to the
REMOTE OUT jack is not the Yamaha component and
does not have the capability of the SCENE control
signals.
Note
If noises are output when you operate the SCENE function, set
"SCENE IR" to "OFF".
■ Tuner frequency step
(Asia and General models only)
Use this feature to set the tuner frequency step according
to the frequency spacing in your area.
Choices: AM10/FM100, AM9/FM50
• Select "AM10/FM100" for North, Central and South
America.
• Select "AM9/FM50" for all other areas.
SCENE IR
TU
■ Parameter initialization INIT
Use this feature to reset the parameters of this unit to the
initial factory settings. You can select the category of
parameters to be initialized.
Choices: DSP PARAM, VIDEO, ALL, CANCEL
• Select "DSP PARAM" to initialize all the parameters
of the sound field programs (see page 61).
• Select "VIDEO" to initialize the parameters in
"VIDEO SET" (see page 85) and "OSD SHIFT" in
"DISPLAY SET" (see page 84).
• Select "ALL" to initialize all the parameters of this
unit.
• Select "CANCEL" to cancel the initialization
procedure.
Note
Use "INITIALIZE" in the sound field program menu to initialize
the parameters of the desired program (see page 61).
Advanced setup
97
En