Page 1
8160 D/8190 D Dunstabzugshaube Afzuigkap Hotte aspirante Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice d’utilisation et d’installation Operating and Installation Instructions...
Open the metal grease filter Charcoal filter Changing the light bulb Cleaning Special accessories Technical assistance service Guarantee conditions Technic Details Mounting accessories included Electrical connection Safety warnings for the electrician Wall unit mounting Printed on recycled paper AEG - putting words into action...
Safety warnings for the user • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control.
Page 4
• The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. • It is advisable to apply for authorization from the relevant controlling authority when connecting the outlet to an unused chimney flue or combustion gas duct.
• The air is filtered through an charcoal filter and returned to the kitchen through the top grill of the outlet pipe. • You will need an original AEG KF8 charcoal filter for the filtering function. (See Special Accessories). • Fix the deflector using 2 screws Ø 2,9x13 mm. Fig. 2.
Hood Operation • Best results are obtained by using a low speed for normal conditions and high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared.
Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Metal grease filter • The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function.
Charcoal filter • The charcoal filter should only be used if you want to use the hood in its filtering function. • To do this you will need an original AEG charcoal filter (see special accessories). • Cleaning/replacing the charcoal filter Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated.
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations.
Cleaning • Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. •...
Guarantee conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation.The guarantee does not...
Page 12
Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home.They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances.
Technic Details (8160 D - in cm): Dimensions 800-1350 x 598X x 470 Height x Width x Depht (8190 D - in cm): Dimensions 820-1370 x 898 x 480 Height x Width x Depht 170 W Maximum absorbed power: 1 x 155 W...
Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the volt- age indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access.
Wall unit mounting - Fig. 7 • Position the template on the wall (1) and mark the position, and drill (2) the holes (2 x Ø 8 mm). • Mount the two wall plugs with the hooks (3). • Hang the hood on the hooks and level it with the adjustment screws (4).
Page 16
Electric hob 500 mm Gas hob 650 mm Fig. 7...
Page 17
Exhaust tube Power outlet Electric hob 500 mm Gas hob 650 mm Wall bracket 8190 D 8160 D Electric hob 500 mm Gas hob 650 mm...