Troubleshooting - Jacuzzi 1.6 GALLON Installation Instructions Manual

One piece toilet

Hide thumbs

Table Of Contents

Table of Contents

Adjustment (B)

1. Before making any adjustments, be sure that the refill

tube is properly inserted into the overflow pipe on the

flush valve to provide full water seal in the bowl.

2. Fill the float cup before operating the valve. Turn on the

water supply valve. Hold the float cup under water

during the first full fill cycle to fill the bottom half of cup

with water for ballast. The water level can be adjusted

by squeezing the water level adjustment clip and moving

float cup up or down along stainless steel link.

3. Be sure that the water level in the tank is always to the water level line marked on the

overflow pipe on the flush valve. This is necessary in order for the unit to consistently

operate on 1.6 gallons of water and maintain satisfactory bowl performance.

TO REMOVE FLUSH VALVE

Gently remove the flapper arms from the

hinge pins to remove the flapper.

Insert the flush valve removal apparatus,

contacting the tabs as shown, and turn the

"ring nut" counterclockwise 1-1/2 to 2 turns

and lift out the entire flush valve reservoir.

POOR FLUSH

Shut-off valve is not fully open.

Water level in tank is too low. (See Adjustments)

Water level in bowl too low (refill tube blocked or not installed into top of overflow

tube) (See Adjustments)

Flapper not lifting and activating flush. (See Adjustments)

FLOAT VALVE DOES NOT FULLY SHUT OFF

Flapper may be defective or warped.

Parts in top of float valve may be worn.

Flapper may not be closing completely due to obstruction or too tight a chain. (See

Adjustments)

Float ball may be lodged against tank wall.

Water level may be too high. (See Adjustments)