Installation Instructions; Unpacking; Location Requirements - Whirlpool [12:36:03] ?????????????????: GC900QPPB Use & Care Manual

Installer: Leave Use and Care Guide with the homeowner.
Homeowner: Keep Use and Care Guide for future reference and
for local electrical inspector's use, if required.

Unpacking

WARNING
Excessive Weight Hazard
Use two or more people to move and install compactor.
Failure to do so can result in back or other injury.
IMPORTANT:
Do not grasp console to move compactor.
Begin in the room where the compactor will be located.
1. Remove compactor from shipping carton.
2. Remove all packaging materials such as tape and shipping
pads.
3. Use a mild detergent and warm water to remove waxy
residue caused by shipping material.
4. Dry thoroughly with a soft cloth. For more information, see
"Cleaning."
5. Be sure the power cord is attached to the cord clip on the
rear of the compactor.
A
A. Cord clip
6. Place the 2 corner posts from the carton on the floor near the
compactor.
7. Open the compactor drawer and remove any shipping
materials or other items from the drawer.
NOTE: Do not remove the compactor bag.
8. Grasp the handle and raise the front of drawer until it clears
the drawer stops.
9. Grasp sides of drawer and lift drawer out of compactor.
10. Place the drawer on the 2 corner posts.
11. Place the other 2 corner posts on the floor to the side of the
compactor.
12. Grasp the sides of the compactor cabinet and put compactor
on its side on top of the corner posts.

INSTALLATION INSTRUCTIONS

13. Remove the shipping base from the bottom of the compactor.
A
A. Leveling legs
B. Shipping base

Location Requirements

Product Dimensions
34 "
(86.7 cm)
(38.1 cm)
Cutout Dimensions
3" min.
(7.6 cm)
A
24" min.
(61 cm)
A. Grounded electrical outlet must be a minimum of 3" (7.6 cm) away
from surrounding cabinets or nearby walls as shown. It can be
placed either to the left or the right side of the product.
B
24"
15"
(61 cm)
34 " min.
(87 cm)
18" min.
(45.7 cm)
15 " min.
(38.7 cm)
3