Installation - Electrolux EWB 75110 W User Manual

8 electrolux

Installation

Remove all protective packaging for transit before
using for the first time. Keep in case needed for
future transit: Transporting a non-secured appli-
ance may damage internal components and cause
leakages and malfunctions. The appliance can al-
so be damaged through physical contact.
Unpacking
1
3
Untying
a 1b
2a
3
2
4
1a 1b
3
2
2b
4
To install your washing machine at the same level
as surrounding furniture, proceed as shown on
picture 4.
Water supply
Install the supplied water inlet hose at the rear of
your washing machine by proceeding as follows.
Do not reuse an old hose. The water inlet hose can
not be extended. If it is too short, please contact
the after-sales service.
1
Open the water inlet tap. Check there are no leaks.
Drainage
Fit the U-piece on the
drainage hose. Place
everything in a drainage
point (or in a sink) at a
height of between 70
and 100 cm. Ensure it is
positioned securely. Air
must be able to enter
the end of the hose, to
avoid any risk of siphon-
ing.
The drain hose must never be stretched. If it is too
short, contact an engineer.
Electrical connection
This washing machine must only be connected in
single-phased 230 V. Check the fuse size: 13 A for
230 V. The appliance must not be connected with
an extension lead or multi-plug adaptor. Ensure
that the plug is earthed and that it is in accordance
with current regulations.
Positioning
Position the appliance on a flat and hard surface in
a ventilated location. Ensure the appliance does
not come into contact with the wall or other furni-
ture. Accurate levelling avoids vibrations, noise
and prevents the appliance from moving when
running.
2