2 electrolux 1. The control panel 2. Lid handle 3. Filter access cover 4. Lever for moving the appliance 5. Adjustable levelling feet CONTROL PANEL Programme selector Pushbuttons and their functions Lights of cycle progress “Start/Pause” pushbutton “Delay start” pushbutton...
3 DISPENSER BOX Prewash Wash Softener (do not fill above the MAX symbol SAFETY INFORMATION Please read these points carefully before in- • Ensure that, after installation, the power stalling and using your appliance. Keep this cable is not trapped under the appliance.
4 electrolux mation which would damage your appli- with petrol, alcohol, trichlorethylen etc. If ance. such stain removers have been used, Before turning your appliance on again, en- wait until the product has evaporated be- sure that it is installed in an area where the fore putting these items into the drum.
5 ing the “Start/Pause” pushbutton (see and then “Delay start” . Press “Start/ “Programmes table”). Press the desired Pause” to start the cycle. button(s) : the corresponding lights come • To change the timer delay period, you on. If pressed again, the lights go out. If one must go through the “Stop”...
6 electrolux to a stop. Turn the programme selector to and the light “End of cycle” comes on. the “Stop” position . Remove washing. The lid can only be opened around 2 mi- Unplug and close water inlet tap. nutes after the washing machine has come...
7 WATER INLET FILTERS To clean, proceed as follows : OPERATING PROBLEMS Numerous checks were carried out on your refer to the sections below before contact- appliance before it left the factory. Howev- ing the after-sales service. er, should you notice a malfunction, please...
8 electrolux Problems Causes The appliance vibrates, • all packaging have not been removed from the appliance (see installa- is noisy: tion section), • the appliance isn’t level and is unbalanced, • the appliance is too close to the wall or furniture, •...
9 INSTALLATION Remove all protective packaging for transit WATER SUPPLY before using for the first time. Keep in case Install the supplied water inlet hose at the needed for future transit: Transporting a rear of your washing machine by proceed- non-secured appliance may damage inter- ing as follows.
10 electrolux Place it on its rollers vents the appliance from moving when run- by pulling the lever ning. located at the base of the appliance hard from right to left. Once the appliance is in the desired po- sition, push the lever back to its original position.