Gas Connection; Electrical Connection - AEG 24968 G-m Use, Installation And Maintenance Instructions

7) GAS CONNECTION

The gas connection is located at the rear and on the
underside of the appliance 100 mm from the right
hand side.
Natural Gas
Natural Gas installations require the connection of a
gas regulator at the appliance.
Assemble the regulator (noting the gas flow
direction) and transition pieces, in accordance with
figure 12.
THE APPLIANCE HAS BEEN FITTED WITH
INJECTORS DESIGNED FOR NATURAL GAS.
LPG (liquified petroleum gas) INJECTORS HAS
BEEN SUPPLIED.
Liquefied Petroleum Gas
In a LPG installation the gas regulation is made at
the gas cylinder and regulation at the appliance is
not required. To connect supply to the appliance
use transition pieces as shown in figure 13.
These pieces are supplied with the appliance on
purchase.
FIG. 12
FIG. 15
INSTALLATION

8) ELECTRICAL CONNECTION

The appliance is supplied with a 1800 mm long
flexible supply lead.
The point of attachment for this lead is located at
the rear and on the underside of the appliance 380
mm from the right hand side.
The voltage and power consumption are detailed on
the underside of the appliance. Ensure that the
appliance is correctly rated to the supply.
Connect appliance by way of a switched power
point.
THE APPLIANCE MUST BE EARTHED. Ensure
that this power point is properly earthed.
Look at the connection wiring diagrams (fig.14, 15,
16 and fig. 17).
FIG. 13
FIG. 16
7
FIG. 14
FIG. 17