Enamelled Parts - AEG 24968 G-m Use, Installation And Maintenance Instructions

WARNING:
Do not wash any part while it is still hot.
2) HOTPLATE
Periodically, the enamelled trivets, burners and
burner caps should be washed with warm soapy
water (fig. 5).
Ensure they are completely dry and that all holes in
the burners are clear of obstructions prior to re-
assembly.
SHOULD THE BURNER CONTROL KNOBS
BECOME DIFFICULT TO OPERATE, THEN SEEK
APPLIANCE SERVICE.

3) ENAMELLED PARTS

To maintain the characteristic brightness of the
enamelled parts, it is necessary that they be
cleaned frequently with warm soapy water. Do not
clean them while they are hot and never use
abrasive powders or cleaners.
Stains may be removed by wiping with a clean cloth
and soapy water before stains become cold.
Stubborn stains may be removed by soaking in hot
soapy water.
Do not allow vinegar, coffee, milk, salty water,
lemon or tomato juice to remain in contact with
enamelled surfaces.
CLEANING
4) PARTS IN STAINLESS STEEL
Parts in stainless steel must be cleaned with warm
soapy water and dried with a clean soft cloth.
Frequent use of cleaning agents designed for
stainless steel is recommended.
FIG. 5
5