Installation - AEG 24968 G-m Use, Installation And Maintenance Instructions

TECHNICAL INFORMATION FOR
INSTALLATION PERSONNEL
WARNING:
This appliance must be installed only by
authorised personnel and in accordance with
AS5601 (AG 601), the manufacturers installation
instructions, relevant municipal building
regulations, gas and electrical authority
regulations.
The wall and bench surfaces must be capable of
sustaining temperatures of 75 degrees Celsius. All
laminates, fixing adhesive and surfacing materials
should be certified suitable for this temperature.
Refer to figure 6 for required clearances around
appliance.
NOTE 1 :
FIRE RESISTANT MATERIAL (eg CERAMIC
TILES) IS REQUIRED TO 450 mm ABOVE
BURNER TOP IF WALL OR VERTICAL
STRUCTURES ARE WITHIN 200 mm FROM
BURNER.
NOTE 2 :
RANGEHOOD AND EXHAUST SYSTEM ARE
NOT PERMITTED WITHIN 600 mm ABOVE
BURNER TOPS.
5) BENCHTOP CUTOUT
The cutout in the bench-top should be made using
the dimensions given in figure 7, 8 the template
provided.
NEVER LEAVE THE PACKING COMPONENTS
(PLASTIC BAGS,
POLYSTYRENE, ETC...) WITHIN THE REACH OF
FIG. 6
FIG. 9

INSTALLATION

NAILS, FOAMED
FIG. 10
THE CHILDREN SINCE THEY ARE A SOURCE OF
POTENTIAL DANGER.
6) FIXING OF THE HOTPLATE
The hotplate is provided with a special seal to
prevent liquid penetrating to the underside of the
appliance.
For correct installation of this seal ensure the
procedures detailed below are followed:
- Unpack the sealing strips ensuring that the
transparent protection is not damaged and
remains attached to the seal.
- Invert the appliance and fix the special clamps to
the underside of the appliance with the screws "G"
(see fig. 9).
- Carefully place the seal around the outer edge of
the appliance. Care should be taken to align the
outer edge of the seal with that of the appliance.
Trim the seal to the correct length to ensure that
no overlap of the seal occurs. Refer figure 10.
- Adhere the seal to the appliance by pressing firmly
with fingers.
- Remove the protective strip from the seal.
- Place the appliance into the cutout in the bench-
top and secure with the special screws and fixing
clamps. Refer figure 11.
- It's necessary to fix a wooden division locked by
screws at a minimun distance of 50 mm from the
bottom of the hob if no oven is installed under the
hob, is advisable also, to provide for drawers
under the same.
FIG. 7
6
FIG. 8
FIG. 11