AEG SANTO Operating Instructions Manual page 36

Something not Working
Symptom
Temperature display shows
a square.
Warning tone sounds, red
warning display and free-
zer temperature display are
flashing.
Interior illumination does
not function.
Water on the floor or on
storage shelves.
Heavy build up of frost,
possibly also on the door
seal.
The compressor does not
start immediately after
changing the temperature
setting.
Noise
If after the above checks there is still a fault, call your local AEG Service
Force Centre.
In-guarantee customers should ensure that the above checks have been
made as the engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
Please note that proof of purchase is required for in-guarantee service
calls.
36
Possible Cause
There is a function fault.
Temperature warning for
freezer.
Light bulb is defective.
Important: The interior
lighting switches off auto-
matically after 20 minutes.
Water drain hole is
blocked.
Door seal is not air tight
(possibly after changing
over the hinges).
This is normal, no error has
occurred.
Appliance is not level.
Solution
Please inform customer
service. Do not open the
door of the appliance
again.
Please check in "Control
and Information System"
section.
Please refer to "Replace
Light Bulb" section.
See the "Maintenance and
Cleaning" section.
Carefully warm the leak-
ing sections of the door
seal with a hair dryer (not
hotter than approx. 50 °C).
At the same time shape the
warmed door seal by hand
such that it sits correctly.
The compressor starts after
a period of time.
Readjust the front levelling
feet.
Refer to Normal Operating
Sounds
818 18 88-00/2