Reprogramming a Single HomeLink
Button
To program a device to HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink
" shown earlier in this section.
Resetting Defaults
®
To reset HomeLink
to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
at 1-800-355-3515, or on the Internet at
www.homelink.com.
®
®
®
using a HomeLink
®
button.
®
®
®
Storage Areas
Glove Box
Open the glove box by pulling the side of the handle
towards the driver side.
Overhead Console
Your vehicle may have this feature. The overhead
console may include a reading lamps, HomeLink
transmitter and a sunroof switch. See Sunroof on
page 2-60 and HomeLink
on page 2-49 for more information.
If your vehicle has a third row seat, and has a power
operated rear quarter glass, the switches for operating
the rear quarter glass are also located in the overhead
console. These switches allow the driver to open
and close each third row seat window separately.
)
(Driver's Quarter Glass): Press button downward
to open or upward to close the drivers side (left)
quarter glass for the third row seat.
(
(Passenger's Quarter Glass): Press button
downward to open or upward to close the passengers
side (right) quarter glass for the third row seat.
®
®
Wireless Control System
2-53