AEG 66301K-mn Installation And Operating Instructions Manual page 23

2. While the control lamp is flashing rapidly, use the
sensor panels to set the desired period of time for this cooking zone up
until the point where it automatically switches itself off (e.g.
15 minutes).
The safety cut-out function will be activated after several minutes
The control lamp will now flash more slowly and the remaining cooking
time will be shown in the display as it elapses. If the safety cut-out
function has been set for more than one cooking zone, the time dis-
played will be that for the cooking zone with the shortest period of
cooking time remaining. The control lamps for the other cooking zones
for which the safety cut-out function has been set will illuminate. To
display the remaining cooking time for any of these cooking zones, it
must be selected using the timer sensor panel, and the corresponding
control lamp will then flash rapidly.
To reset the remaining cooking time the desired cooking zone must be
selected using the timer sensor panel. The corresponding control lamp
will then flash more rapidly. The settings are reset using the
timer setting sensor panels.
After the set period of cooking time has elapsed the cooking zone au-
tomatically switches itself off, an acoustic signal sounds for two min-
utes and the timer display flashes 00.
3. To switch off the signal, touch the timer sensor panel.
3
To make the setting more quickly, touch any of the
ting sensor panels until the desired value is reached.
If the timer setting sensor panel is actuated first, the time setting
will begin at 99 minutes, and if the
tuated first, the time setting will begin at 1 minute.
or
or
timer setting sensor panel is ac-
timersetting
or
timer set-
23