Preparing Your Handset; Bt Freelance Xc1100 Multipack Users Only - BT FREELANCE XC 1100 User Manual

Preparing your handset

2. Insert the 2 x AAA rechargeable batteries supplied, taking
note of the polarity markings inside the battery compartment,
then slide the battery compartment shut.
3. Place the handset on the base to charge. It will beep when
placed in and the battery icon on the handset will flash to
indicate charging. You should let the batteries charge
continuously for at least 24 hours. The batteries and case may
become warm during charging, this is normal.

BT Freelance XC1100 multipack users only:

If you have purchased a BT Freelance XC1100 multiple pack,
you will need to prepare any additional handsets and charger
for use. Place each BT Freelance XC1100 charger within reach
of a mains power wall socket.
For each additional handset and charger:
i. Plug the mains power adaptor into the power socket on the
underside of the charger and plug the other end into the
mains power wall socket.
ii. Insert the 2 x AAA rechargeable batteries supplied, taking
note of the polarity markings inside the battery compartment,
then slide the battery compartment shut.
If you experience any problems, please call the Helpline on 0870 242 6652*
Getting started
WARNING
Never use non-rechargeable batteries.
Only use the approved batteries. Using
unapproved batteries will invalidate
your guarantee and may damage the
telephone.
Talk/Standby time
Under ideal conditions, the handset
batteries should give up to 10 hours
talk time or 100 hours standby on a
single charge.
(This does not mean you can unplug
the base or leave the handset for this
length of time without charge).
Please note that new NiMH
rechargeable batteries do not reach
full capacity until they have been in
normal use for several days.
See 'Battery performance' on the
following page.
Battery low warning
If the icon is flashing in the display
and you hear a warning beep every
minute during a call, you will need to
recharge your handset before you can
use it.
7