Table of Contents
Advertisement
Important!
The salt refill indicator light on the control panel can remain illuminated for 2-6 hours after
salt has been replenished, assuring the dishwasher remains on. If you are using salts that take
longer to dissolve then this can take longer. the function of the dishwasher is not affected.
The rinse-aid
The rinse-aid ensures brilliant crockery and also helps it to dry. It is automatically dosed in during
the hot rinsing cycle. The storage compartment built in to the inside of the door can hold about
110 ml of rinse-aid, which will be sufficient for between 16 and 40 dishwashing programmes,
according to the dosage setting.
Filling up the rinse-aid
1. Open the container by turning the lid (A) anticlockwise.
2. Add the rinse aid until the container is completely full. The indicator (B) will be completely
dark.
BR01
Ensure that the lid is closed after every refill.
Top up with rinse aid when the indicator (B) becomes clear.
Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during
the next wash.
Attention! Do not put liquid detergent in the rinse aid compartment.
Adjusting the dose
The correct dosage of the rinse-aid should be regulated on the
basis of the shine and drying results.
For this purpose, set the quantity of liquid by means of the
six-position selector (C) located on the inside of the filler
opening (minimum quantity is position 1, maximum quantity
is position 6).
Use the tip of a knife or a screwdriver to rotate the selector. If
drops of water or white marks remain on the crockery after it
has been washed, increase the dosage. If the crockery comes
out with whitish, sticky streaks, reduce the dosage.
BR03
BR02
11
Advertisement
Table of Contents
