Page 1
ÖKO_FAVORIT 5070 Dishwasher User Instructions...
Page 2
In the event of a malfunction, these operating instructions contain information on how to rectify faults yourself, see the "What to do, if..." section. If these instructions are insufficient, please contact your AEG Service Force Centre. In this respect please read the chapter "Service & Spare Parts".
General safety • Repairs to the dishwasher may only be performed by qualified service engineers. Improper repairs can give rise to significant hazards for the user. If your appliance needs repairing, please contact your local AEG Service Force Centre.
• If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG Service Force) must be changed by a service engineer authorised by AEG. • Never unplug the appliance by pulling on the cable, always pull on the plug.
Operating instructions • In the event of a fault, shut off the water supply at the tap, then switch off the appliance and unplug. In the case of a permanent con- nection: remove the fuse. Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly.
Operating instructions Appliance Features and Control Panel Top Spray Nozzle Rubber Seal for Connecting the Water Feed to the Upper Spray Spray Arms Container for Salt Container for Rinse Aid Detergent Dispenser Rating Filters Plate...
Operating instructions Control Panel Function Softener Button Button Door Handle Indicators Control Field Display for the Individual Wash Programme Steps The Control Field comprises the ON/OFF button and the programme buttons with LED indicators. Softener and Function Button: In addition to the wash programme marked, the dishwasher's water softener is adjusted using a combina- tion of these buttons.
Operating instructions Adjust the Water Softener To avoid the scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content, water. The dish- washer therefore has a built-in water softener, in which tap water from a hardness of 4 °d (German degree) is softened with the aid of special salt.
Operating instructions increases the hardness setting by 1. 5. Pressing the water softener button (Exception: hardness setting 0 follows hardness setting 9). 6. When the hardness setting is correct, press the ON/OFF switch. The hardness setting is then saved. Filling with Salt for the Water Softener Use only special salt for dishwashers.
Operating instructions 6. Turn the lid clockwise to the stop, otherwise dishwasher salt will leak into the wash water, this could lead to poor wash results. To avoid this run a rinse program after filling the salt container with special salt. This will wash away salt water and any salt crystals that have been spilt.
Operating instructions 3. Fill with rinse aid, up to the broken line (maximum); this line corresponds to a quantity of approx. 150 ml 4. Replace the lid and tighten by turn- ing clockwise. 5. If rinse aid has been spilt, wipe up with a cloth.
Operating instructions Loading Cutlery and Dishes Sponges, household cloths and any object that can absorb water should not be washed in the dishwasher For washing in the dishwasher the following cutlery/dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, •...
Operating instructions Loading Cutlery Long bladed knives stored in an upright position are a potential haz- ard. Long and/or sharp items of cutlery such as carving knives must be posi- tioned horizontally in the upper bas- ket. Take care when loading or unloading sharp items such as knives.
Operating instructions Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rack. To ease the loading of large items at some dishwasher-models the two rows of prongs for the right-hand plate insert can be folded down: 1.
Operating instructions Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items.
Operating instructions Adjusting the Height of the Upper Basket Maximum Height of the Dishes in the Upper Basket Lower Basket With upper basket raised 22 cm 31 cm With upper basket lowered 24 cm 29 cm The height of the basket can also be adjusted when it is loaded. Depending on the model, your appliance is provided with one of the following types of upper basket: Lowering the Upper Basket:...
Operating instructions Filling with Detergent Use only dishwasher detergent. Fill with Detergent: – Prior to the start of a wash programme (not for the Pre Wash pro- gramme). The detergent is released into the wash water during the programme. Please observe the manufacturer’s dosing and storage recommenda- tions given on the detergent packaging.
Operating instructions Bio Wash Programmes and Concentrated Detergents Based on their chemical composition, dishwasher detergents can be split into two basic types: – Conventional, alkaline detergents with caustic components – Weak alkaline concentrated detergents with natural enzymes. The use of BIO wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;...
Operating instructions Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Dessert Dishes Type of Dinner Service and Cooking Utensils and Coffee All Dish Types Dishes Service In Addition with non-tem- with perature resist- delicate glasses...
Operating instructions Start the Wash Programme 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the ON/OFF button. The ON/OFF button indicator illuminates. 5.
Operating instructions Cancelling the wash programme 1. Press the button for the current wash programme and hold it pressed. The programme indicator for the current wash programme flashes for a few seconds and then extinguishes. 2. Release the programme button, the wash programme is cancelled. A selected programme is only interrupted by switching off the dish- washer, it is not cancelled.
Operating instructions Care and Cleaning Do not under any circumstances use furniture care products or aggres- sive cleaners. • If necessary, clean the controls only with a soft cloth and pure warm water. • The spray arms do not need cleaning. •...
Page 25
Operating instructions 7. Put the flat filter back in the base of the washing compartment 8. Place the coarse/fine filter in the microfilter and press together. 9. Put the filter combination in place and lock by turning the handle clock- wise to the stop.
After rectifying an END or DRYING fault, press the button for the wash programme that has been started. The wash programme should continue. If the fault is displayed again, contact AEG Service Force. • If indicators for other programme steps on the programme progress display are flashing, please contact AEG Service Force and state the fault indicated.
Operating instructions ...there are problems with the operation of the dish- washer. Symptom Possible Cause Solution The door of the dishwasher is Shut the door. not closed properly. Mains plug is not plugged in. Insert mains plug. The programme does House fuse is defective.
Operating instructions There are streaks, milky spots or a bluish coating on glasses and dishes. – Lower rinse aid dosing. There are dried water drops on the glasses and dishes. – Increase rinse aid dosing. – The detergent may be the cause. Contact the detergent manufac- turer’s customer advisor.
Operating instructions Notes for Test Institutes The salt container for the water softener and the rinse aid container must be completely full prior to the test. Test Standard: EN 5O 242 Comparative Programme: Normal BIO 50 °C for full and half load Full Load: 12 place settings incl.
Installation and Connection Instructions INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of surrounding units extend the threaded feet by unscrew- ing:...
Installation and Connection Instructions • Depending on type, the dishwasher is to be installed as follows: Dishwashers That Can Be Integrated (see installation template supplied) The door of the appliance can be fitted with a wooden/facing panel with the following dimensions: Width 591 –...
Page 32
Installation and Connection Instructions • If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows: – Unscrew the screws (1) from the elbows on the back side. –...
Installation and Connection Instructions Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. • The dishwasher can be connected to cold and hot water supplies up to max.
– Minimum required height 30 cm above the lower edge of the machine. Extension hoses • Extension hoses are available from AEG Service Force. The internal diameter of the extension hoses must be 19 mm to ensure that the function of the appliance is not impeded.
Installation and Connection Instructions Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the drain pump switches on. By this means water can neither escape nor overflow.
Installation and Connection Instructions Electrical Connection Any electrical work required to install this appliance should be car- ried out by a qualified electrician or competent person. WARNING - This appliance must be earthed. The manufacturer declines any responsibility should these safety measures not be observed.
Installation and Connection Instructions Connections The water inlet and drain hoses, as well as the mains cable must be con- nected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation.
3. Should guarantee repairs be necessary the purchaser must inform the nearest customer service office (manufacturer´s service or authorised agent). AEG reserves the right to stipulate the place of the repair (i. e. the customer´s home, place of installation or AEG workshop).
In diesen Ländern gelten die Garantiebedingungen der örtlichen Part- ner. Diese können dort eingesehen werden. Further after-sales service agencies overseas In these countries our AEG agents’ own guarantee conditions are appli- cable. Please obtain further details direct. Autres agences étrangères assurant le service après-vente Dans ces pays, les conditions de garantie des concessionnaires de la région sont valables.
Customer Care For general enquiries concerning your AEG appliance or for further information on AEG products please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.aeghome.co.uk.