Speedometer - Yamaha XVS1100 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
4. Engine trouble indicator light
" "
This indicator light will come on or flash
if trouble occurs in a monitoring circuit.
In such a case, take the motorcycle to a
Yamaha dealer to have the self-diag-
nostic systems checked.
3
To check that the engine trouble indica-
tor light is working properly:
Turn the main switch to "ON". If the en-
gine trouble indicator light does not
come on, have a Yamaha dealer in-
spect the electrical circuit.
5. High beam indicator light "
This indicator comes on when the
headlight high beam is used.
EAU01672*
1. Trip button
2. Odometer/Trip meter

Speedometer

This speedometer is equipped with an
odometer and a trip meter. Pushing the
"TRIP" button will change the display
EAU00063
from one to the other. When set to
"
"ODO", it indicates the motorcycle's to-
tal mileage. When set to "TRIP", it indi-
cates the motorcycle's mileage since
the trip meter was last reset. Use the
trip meter to estimate how far you can
ride on a tank of fuel. This information
will enable you to plan fuel stops in the
future.
To reset the trip meter to "0", push the
EAU01202
"TRIP" button until it displays "TRIP",
then push it once again and hold it
down for at least one second.
NOTE:
@
This motorcycle does not have a ta-
chometer. However, it is equipped with
an engine speed limiter, which pre-
vents the engine speed from exceed-
ing approximately 6,800 r/min and the
vehicle from exceeding a top riding
speed of approximately 175 km/h.
@
3-3