Yamaha YZF-R6 Owner's Manual page 62

PERIODIC MAINTENANCE AND ADJUSTMENT
1. Cowling A
2. Turn signal light lead coupler
6
1. Cowling B
2. Turn signal light lead coupler
To install a cowling
1. Connect the turn signal light lead
coupler.
2. Fit the projections into the slots,
slide the cowling rearward, and
then fit the forward-most projection
into the slot.
1. Cowling A
2. Turn signal light lead coupler
1. Cowling B
2. Turn signal light lead coupler
6-10
3. Fit the projection on cowling A into
the hole in cowling B as shown.
1. Cowling A
2. Cowling B
4. Install the bolts, quick fasteners,
and quick fastener screw.
Cowling C
To remove the cowling
1. Remove cowling B and panel B.
(See page 6-8.)
2. Unfasten the wire harness by
pressing on the projection to open
the plastic fastener.
EAU39092