Yamaha YZF-R6 Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 16500 r/min and above
Clock
1
3
km/h
1. Clock
To set the clock
1. Turn the key to "ON".
2. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
3. When the hour digits start flashing,
push the "RESET" button to set the
hours.
4. Push the "SELECT" button, and
the minute digits will start flashing.
ECA10031 5. Push the "RESET" button to set
the minutes.
6. Push the "SELECT" button and
then release it to start the clock.
Odometer, tripmeter, and stopwatch
modes
TRIP A
1. Odometer/tripmeter/fuel reserve tripme-
ter/stopwatch
Push the "SELECT" button to switch
the display between the odometer
mode "ODO", the tripmeter modes
"TRIP A" and "TRIP B" and the stop-
watch mode in the following order:
TRIP A → TRIP B → ODO → Stop-
watch → TRIP A
If the fuel level warning light comes on
(see page 3-4), the odometer display
will automatically change to the fuel re-
serve tripmeter mode "F-TRIP" and
start counting the distance traveled
from that point. In that case, push the
"SELECT" button to switch the display
between the various tripmeter, odome-
ter, and stopwatch modes in the follow-
ing order:
F-TRIP → Stopwatch → TRIP A →
TRIP B → ODO → F-TRIP
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
TRIP A
˚C
push the "RESET" button for at least
1
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km (3 mi).
Stopwatch mode
To change the display to the stopwatch
mode, select it by pushing the "SE-
LECT" button. (The stopwatch digits
will start flashing.) Release the "SE-
LECT" button, and then push it again
for a few seconds until the stopwatch
digits stop flashing.
3-9