Table of Contents
Advertisement
find which temperature setting (fabric
type) matches which steam setting in
the ironing table. As soon as the iron is
held horizontally steam begins to form.
When the iron is set upright again the
steam supply stops automatically.
Spray function (Figure 6/A)
The first time you use the appliance, or
if you have not used it for a long time,
you will need to press the spray button
(Figure 1/G) several times before water
comes out of the spray nozzle
(Figure 1/D). You can also use the
spray function when dry ironing.
Super steam jet function
(Figure 6/B)
The super steam jet is of valuable
assistance when ironing, for example,
creases, embroidery etc. You can trig-
ger the additional steam jet both when
steam ironing and when dry ironing.
0 Set the temperature selector (Figure
1/N) to the "MAX" position and wait
until the correct temperature has been
reached, i.e., until the power indicator
(Figure 1/J) goes out.
0 Raise the steam iron a little away from
the material and press the steam jet
button (Figure 1/H).
Always wait another 5 seconds before
pressing the steam jet button again.
Steaming hanging articles
0 Turn the temperature selector (Figure
1/N) to the "MAX" position and wait
until the power indicator (Figure 1/J)
goes out.
0 Hang the article concerned on a
hanger and hold the steam iron at a
distance of 10 - 20 cm from the mate-
rial.
0 Now press the steam jet button (Figure
1/H). Wait at least 5 seconds before
pressing the button again.
Important: Do not attempt to freshen
1
up clothing whilst it is still being worn.
Risk of burns!
Storage
Remove the plug from the socket!
Set the temperature selector (Figure
1/N) to the "Cold" position (Figure 2/A)
and the steam switch (Figure 1/F) to
position "0" (Figure 4/A).
Empty out remaining water (Figure 7).
Store the appliance standing upright.
To store properly wrap the mains cord
around the cord storage (Figures 1/K
and 8).
Care and maintenance
Self-cleaning function
We recommend carrying out self-
cleaning every two weeks. However,
the period between self-cleaning
should be shorter for harder water
types.
Carry out the self-cleaning function as
follows:
0 Unplug from the mains.
0 Set the steam switch (Figure 1/F) to
position "0" (Figure 4/A).
0 Fill the water reservoir (Figure 1/O) to
the "MAX"mark.
0 Set the temperature selector (Figure
1/N) to "MAX".
0 Insert the plug into the socket.
0 Wait until the power indicator (Figure
1/J) goes out.
0 Pull out the mains plug.
0 Hold the iron horizontally over a sink.
0 Set the steam switch (Figure 1/F) to the
"Self Clean" position (Figure 4/C) and
hold it firmly in place.
0 Steam and hot water will now run out
of the steam exit holes (Figure 1/C).
Move the iron gently to and fro above
the sink until the water reservoir is
empty.
0 Allow the iron to cool and wipe the
soleplate dry with a soft cloth.
g
7
Advertisement
Table of Contents
