Toyota FJ Cruiser User Manual page 85

05 11.29
TS13050
4. To remove the infant seat, press the
buckle release button and allow the
belt to retract completely. The belt will
move freely again and be ready to
work for an adult or older child passen-
ger.
TS13051a
(B) CONVERTIBLE SEAT INSTALLATION
A convertible seat must be used in for-
ward−facing or rear−facing position de-
pending on the age and size of the
child. When installing, follow
manufacturer's instructions about the
applicable age and size of the child as
well as directions for installing the
child restraint system.
2007 FJ CRUISER from Jan. '06 Prod. (OM35857U)
Install the child restraint system on the
front passenger seat only when it is un-
avoidable. Your vehicle is equipped with a
front passenger occupant
system. In order to activate the occupant
classification system correctly, install the
forward−facing child restraint system on
the front passenger seat in the following
order:
1. Turn the ignition key to the "ON" posi-
tion.
2. Move the front passenger seat to the
rearward position.
3. If you must install the child restraint
system on the front passenger seat,
put the child restraint system putting
your weight on the front passenger
seat.
the
4. Insert the seat belt tab into the seat
belt buckle.
5. Fully extend the shoulder belt to put it
in the lock mode. When the belt is
then retracted even slightly, it cannot
be extended. To hold the seat securely,
make sure the belt is in the lock mode
before letting the belt retract.
classification
71