Table of Contents
Advertisement
Problem
The pyrolytic cleaning does not
operate (the clock display
shows „C1")
The pyrolytic cleaning does not
operate (the time display shows
„C3")
The turn spit does not rotate
The display shows F102
The display shows an error code
that is not in this list
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the appliance cavity.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
INSTALLATION
WARNING!
Refer to "Safety information" chapter.
The built-in unit must meet the stability requirements of DIN 68930.
Possible cause
The shelf support/telescopic
runners are not removed
The door is not correctly closed
or door lock is defective
The turn spit is not correctly
installed into the turnspit hole
• The door is not closed cor-
rectly
• The door lock is defect
There is an electronic fault
Installation
Solution
Remove support/telescopic
runners
Close the door correctly
Refer to "Turn spit"
• Close the door correctly
• Switch off the appliance
with the house fuse or the
safety switch in the fuse box
and switch it on again
• If the display shows F102
again, refer to the Customer
Care Department
• Switch off the appliance
with the house fuse or the
safety switch in the fuse box
and switch it on again
• If the display shows the er-
ror code again, refer to the
Customer Care Department
.........................................
.........................................
.........................................
31
Advertisement
Table of Contents
