Table of Contents
Advertisement
Used to connect to the host computer' s power supply (DC 5V/12V)
Caution: Be careful not to reverse the poser connector when
attaching it. A reversed connection may cause damage to the
equipment (not covered by the warranty).
2.8 E-IDE Connector
Use a 40 pin double-end flat E-IDE cable to connect to the E-IDE interface.
Caution: Connecting or disconnecting connectors while power
is on may result in a short circuit, causing damage to the
equipment. When connecting or disconnecting connectors,
make sure to turn off the power beforehand.
2.9 Audio Output Connector
Used to connect to the sound card. (Analog signal.)
2.10 Digital Audio Output (Not used)
Used to connect to the sound card. (Digital signal.) It is not used with this
drive.
2.11 Device Configuration Jumper
Used when selecting the Device Configuration of E-IDE. Don't use jumpers
to change anything besides the Device Configuration, but keep the drive as
initially set ("Master" position). Configuration changes become valid after
power is turned off, then on again.
Caution: Installing jumper pins besides the ones for Device
Configuration settings may be the cause of damage or
abnormal drive operation.
Fig. 4 Device Configuration Jumper
The Device Configuration Jumper will be set to Master as factory setting.
5
Advertisement
Table of Contents
