AOpen DUW160812X0502A User Manual page 19

Hardware Installaiton
1. Remove the housing or casing of your computer. Be careful of any sharp edges,
which might be hidden inside your computer.
2. If there is not any other CD-ROM drive installed in your system.
We recommend installing the 16x DVD Dual in the Secondary IDE port. It is
unnecessary to adjust any other jumpers on the 16x DVD Dual. Proceed to step 4
for further installation.
3. If a CD-ROM drive is already installed in your system.
We recommend that you install the CD-ROM on the Secondary IDE
channel as the master device (MA), and the 16x DVD Dual on the
Secondary IDE channel as the slave device (SL). Please follow the steps
below to fulfill this arrangement.
First make sure that your Secondary IDE cable has two ports available for two
IDE devices. If not, ask your main board vendor or purchase one from computer
hardware stores.
If the CD-ROM drive was installed in the Primary IDE channel, disconnect it
from the Primary IDE cable.
Adjust the Device Configuration Jumper of the CD-ROM drive to "Master" (MA)
position.
Adjust the Device Configuration Jumper of the 16x DVD Dual to "Slave" (SL)
position.
-- E-16 --
English