Siemens SL2-141 User Manual page 85

Chapter 5:Connection Mode
Primary IP Address:
Type in the IP address that you got from your
ISP for LAN interface.
Subnet Mask:
Type in the subnet mask that you got from
your ISP for LAN interface.
MTU:
It means the maximum size of the packet
that transmitted in the network. The packet
of the data greater than the number set here
will be divided into several packets for
transmitting. Type in the number into the
field of MTU. The default setting is 1500.
DHCP Server On:
Check this item if DHCP service is needed
on the LAN. The router will assign IP
address, gateway address for each of your
PCs.
Start IP Address:
Type in the start point IP address.
End IP Address:
Type in the end point IP address.
Leased Time:
Type in the duration for the time. The default
is 1day.
DHCP Server Off:
Check this item if DHCP service isn't
needed on the LAN.
Click Next to get into next web page.
You can check it at this time. If you find
something is incorrect, click Back to change
the settings. If everything is OK, click
Finish to accept these settings. And the
following page will appear.
Now, the system will reboot to activate the
new settings that you have done in this
section.
Please wait for 2 minutes for restarting the
router.
77