Electrolux WA GL6 S 101 User Manual page 9

To restart the programme from the point at
which it was interrupted, press the button 8
again.
If an incorrect option is selected, the yellow
pilot light of the button 8 blinks for 3 times the
message Err is displayed for about 2 sec-
onds.
Select the DELAY START (Button 9)
Before you start the programme , if you
wish to delay the start, press the button re-
peatedly, to select the desired delay.
The selected delay time value (up to 20
hours) will appear on the display for about 3
seconds, then the duration of the pro-
gramme will appear again.
You must select this option after you have set
the programme and before you press the
button 8 .
The wash programme can be delayed from
30 min - 60 min - 90 min, 2 hours and then
by 1 hour up to a maximum of 20 hours by
means of this button.
If you wish to add laundry in the machine
during the delay time you will press button
8 to put the machine in pause. Add the laun-
dry, close the door and press button 8 again.
Selecting the delayed start.
• Select the programme and the required
options.
• Select the delay start.
• Press button 8 : the appliance starts its
hourly countdown. The programme will
start after the selected delay has expired.
Cancelling the delayed start
• Set the washing machine to PAUSE by
pressing the button 8 ;
• Press button 9 once until the symbol
displayed;
• Press the button 8 again to start the pro-
gramme.
Important!
• The selected delay can be changed only
after selecting the washing programme
again.
• The door will be locked throughout the de-
lay time. If you need to open the door, you
must first set the washing machine to
PAUSE by pressing the button 8 . After you
have closed the door, press the button 8
again.
The button 9 can not be selected with DRAIN
programme.
Select an additional rinse
This appliance is designed for saving water.
However, for people with a very delicate skin
(allergic to detergents) it may be necessary
to rinse the laundry using an extra quantity of
water (extra rinse).
Press simultaneously buttons 2 and 3 for
some seconds: the pilot light 10.3 comes on.
This function stays permanently on. To re-
move it press the same buttons again until
the pilot light 10.3 goes off.
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out. Before you
make any change, you must pause the
washing machine by pressing the button 8 .
Changing a running programme is possible
only by resetting it . Turn the programme
selector dial to
gramme position. Start the new programme
by pressing the 8 button again. The washing
water in the tub will not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme
which is running, the corresponding light
starts blinking. Press the button again to re-
start the programme.
Cancelling a programme
Turn the selector dial to
gramme which is running. Now you can se-
lect a new programme.
' is
Opening the door after the programme
has started
First set the machine to pause by pressing
the button 8 . If the pilot light 10.2 goes off,
after some minutes the door can be opened.
If the door remains locked - the pilot light
10.2 is on, this means that the machine is
already heating, that the water level is above
the bottom edge of the door. In this case the
door can not be opened. If you cannot open
the door but you need to open it you have to
switch the machine off by turning the selector
dial to . After some minutes the door can
be opened (pay attention to the water lev-
el and temperature !) .
electrolux 9
and then to the new pro-
to cancel a pro-