Electrolux WA GL6 S 101 User Manual page 22

22 electrolux
4. Slide out the relevant plastic spacers.
5. Fill the smaller upper hole and the two
large ones with the corresponding plastic
plug caps supplied in the bag containing
the instruction booklet.
Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the ma-
chine is not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the
floor by putting pieces of wood, cardboard
or similar materials under the machine.
If it is impossible to avoid positioning the ma-
chine next to a gas cooker or coalburning
stove, an insulating panel covered with alu-
minium foil on the side facing the cooker or
stove, must be inserted between the two ap-
pliances.
The machine must not be installed in rooms
where the temperature can drop below 0°C.
The water inlet hose and the drain hose must
not be kinked.
Please ensure that when the appliance is in-
stalled, it is easily accessible for the engineer
in the event of a breakdown.
Carefully level by screwing the adjustable feet
in or out. Never place cardboard, wood or
similar materials under the machine to com-
pensate for any unevenness in the floor.
Water inlet
An inlet hose is supplied and can be found
inside the machine drum.
Caution! This appliance must be
connected to a cold water supply.
Do not use the hose from your pre-
vious machine to connect to the wa-
ter supply.
1. Open the porthole and extract the inlet
hose.
2. Connect the hose with the angled con-
nection to the machine.