AEG FAVORIT 43470 I User Information page 8

Operating instructions
Setting electronically:
1. Press the ON/OFF button.
If indicators other than the ON/OFF button are lit, a programme
has been selected. The programme must be cancelled:
Press function buttons 2 and 3 simultaneously for approx. 2 seconds.
All other indicators will go out.
2. Press function buttons 2 and 3 simultaneously and keep them
pressed. The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 1 again.
The LED indicator for function button 1 will flash, at the same time
the indicator light ENDE starts to flash.
The current level is indicated by the number of flashes of the
indicator light ENDE.
4. Pressing function button 1 increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
5. When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to "1", this switches off the
control indicator for special salt.
Water hardness
in °d 1
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
unter 4
1) (°d) German degree, measure of water hardness
2) (mmol/l) millimol per litre, international unit for water hardness
*) factory setting
8
in mmol/l 2
Range
9,0 - 12,5
7,6 - 8,9
6,5 - 7,5 IV
5,1 - 6,4
4,0 - 5,0
3,3 - 3,9
III
2,6 - 3,2
1,9 - 2,5 II
0,7 - 1,8 I/II
unter 0,7 I
Adjusting the hardness
setting
Manual Electronic
10
9
8
*2
7
6
5
4*
3
2
1
1
no salt
necessary
Number of
flashes
10
9
8
7
6
5
4
3
2
1