What To Do When - AEG FAVORIT 43470 I User Information

Operating instructions

What to do when...

Remedying minor faults.
If any of the indicators in the control panel, as listed in the table
below, are flashing or are illuminated, you can probably rectify the
foult yourself.
After remedying the error that is flashing in the first or second
rhythm in the programme progress display, press the button of the
selected programme. The programme will continue.
In the fault is displayed again, please contact your local Service Force
Centre and inform them of the fault code.
Malfunction
The indicator for the
selected programme is
flashing. In the
programme sequence
indicators ENDE is
flashing in the following
rhythm: one short flash
with approx. 5 seconds
pause in between.
There is no water
running into the
dishwasher.
22
Possible cause
The tap is blocked or
furred with lime-scale.
The tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked
Filters in the base of the
washing compartment are
blocked.
The water inlet hose has not
been correctly laid.
Remedy
Clean tap.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Press the button for the
selected programme;
then cancel the programme
by pressing RESET (see
chapter: Starting a
programme); Clean out the
filters. (See chapter:
Cleaning the filters).
Check hose installation.