Power Wheels G5107 Owner's Manual With Assembly Instructions page 9

5
• Tighten the nut in the lower clamp with the Allen wrench.
Do not over-tighten.
6
Brake
Cable
Cut Off
Excess
Plastic Tie
• Make sure the handlebar is in its highest position.
Hint: Please see Assembly Step 1 on page 8.
• Wrap the plastic tie around the brake cable, power wire
and the handlebar.
• Insert the flat end of the plastic tie into the opening
in the square end of the plastic tie. Pull the flat end of
the plastic tie with pliers to be sure it is tight around
the handlebar.
• Using safety scissors, cut off the excess plastic tie.
Throw the excess plastic tie away.
Assembly
Lower
Clamp
Allen
Wrench
Handlebar
Power Wire
Plastic Tie
7
Head Tube
Fork
Front
Wheel
• Adjust the handlebar so that the brake handle is towards
the front of the scooter.
• Fit the front wheel onto the head tube so that the fork
bends toward the front of the scooter.
8
• Insert a bolt through one side of the fork, head tube and
out through the other side of the fork.
• Turn the front wheel so that it is sideways, as shown.
• Attach the nut to the bolt. While holding the nut with an
adjustable wrench, tighten the bolt with the Allen wrench.
Do not over-tighten.
IMPORTANT! Assembly is now complete, but you must
adjust the brake before first-time use. Please proceed
to the next section Adjusting the Brakes, page 10.
9
Brake Handle
Front of
Scooter