Adjusting The Brake - Power Wheels G5107 Owner's Manual With Assembly Instructions

F
IMPORTANT! Check to be sure the brake is adjusted properly and is tight. Please follow these instructions
carefully before you use this scooter.
1
No Gap
✔
OK
• From the front of the handlebar, examine the brake
handle and the brake base.
- If there is NO gap between the brake base and the
brake handle, your brake is properly adjusted. Please
proceed to the label decoration section on page 12.
- If there IS a gap between the brake base and the
brake handle, your brake needs to be adjusted and
tightened. Please go on to step 2 in this section.
2
Adjustment
Lock Nut
• Turn the lock nut clockwise a few times to loosen it.
• Turn the brake adjustment knob clockwise a few times to
tighten the brake and close the gap between the brake
base and brake handle.
• When the gap is closed, hold the brake adjustment knob
in position and turn the lock nut counter-clockwise tight
against the brake base to secure the adjustment.

Adjusting the Brake

Gap
Adjust Brake
Turn
Lock Nut
Brake
Hold Brake
Adjustment
Knob
Knob
3
No Gap
✔
OK
• Now, from the front of the handlebar, examine the brake
handle again.
- If there is NO gap between the brake base and the
brake handle your brake is properly adjusted. Please
proceed to the label decoration section on page 12.
- If you cannot eliminate the gap or if the brake
adjustment knob unthreads from the brake base,
proceed to step 4.
Brake Adjustment
4
Knob
Lock Nut
• Turn the lock nut clockwise until it stops against the
brake adjustment knob.
• Turn the brake adjustment knob counter-clockwise until
the lock nut stops against the brake base.
10
Gap
Adjust Brake
Brake
Adjustment
Knob
Brake Base
Lock Nut