Assembly - Power Wheels G5107 Owner's Manual With Assembly Instructions

E
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
scooter's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the scooter. Children
should not handle parts, including the
battery, or help in assembly of the scooter.
1
Handlebar
• Open the upper clamp on the handlebar.
• Lift the handlebar to its highest position.
• Close the upper clamp on the handlebar.
2
Lower
Clamp
• Loosen the nut in the lower clamp on the handlebar with
the Allen wrench.

Assembly

Upper
Clamp
Allen
Wrench
8
3
Handlebar
Handle
Tube
• Note the location of the colored dot on the handle tube.
• Fit the handlebar onto the handle tube.
IMPORTANT! Make sure the colored dot on the handle
tube is visible through the slot in the handlebar.
4
M5 x 12mm Screw
SHOWN ACTUAL SIZE
• Align the hole in the front of the lower clamp, handle
tube and handle bar.
• Insert the M5 x 12mm screw through the hole in the
clamp and into the handlebar and handle tube.
Tighten the screw with a Phillips screwdriver.
Handlebar
Slot
Handle Tube
Colored Dot
Inside View
Colored
Dot
Inside View