Yamaha MidnightStar XV1900A Owner's Manual page 25

Right
1. Engine stop switch " / "
2. Hazard switch " "
3. Start switch " "
Dimmer " / "/Pass "
Set this switch to " " for the high
beam and to " " for the low beam.
To flash the high beam, press on the
low-beam side " " of the dimmer
switch while the headlight is on low-
beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
INSTRUMENT AND CONTROL FUNCTIONS
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU40750
" switch
Start switch "
Push this switch to crank the engine
with the starter.
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
EAU12460
"
The engine trouble warning light will
come on when the key is turned to "ON"
". When re-
and the start switch is pushed, but this
does not indicate a malfunction.
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12500
" turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
EAU12660
/ "
might be a traffic hazard.
" before starting
" to
CAUTION:
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12710
"
"SELECT" switch
This switch is used to perform selec-
ECA10050
tions in the odometer, tripmeter, to set
the clock and to set the brightness
mode of the multi-function meter unit.
See "Multi-function meter unit" on page
3-5 for detailed information.
EAU41700
3-11
EAU12733
"
" posi-
3
ECA10061
EAU44600