Changing The Brake Fluid; Checking And Lubricating The Cables - Yamaha VMAX VMX12 Owner's Manual

Vmax 2000
Hide thumbs Also See for VMAX VMX12:
Table of Contents

Advertisement

Brake fluid may deteriorate paint-
ed surfaces or plastic parts. Al-
ways
clean
up
spilled
immediately.
As the brake pads wear, it is nor-
mal for the brake fluid level to
gradually go down. However, if the
brake fluid level goes down sud-
denly, have a Yamaha dealer
check the cause.
PERIODIC MAINTENANCE AND MINOR REPAIR

Changing the brake fluid

Have a Yamaha dealer change the
fluid
brake fluid at the intervals specified in
the periodic maintenance and lubrica-
tion chart. In addition, have the oil seals
of the brake master cylinder and caliper
as well as the brake hose replaced at
the intervals listed below or whenever
they are damaged or leaking.
Oil seals: Replace every two
years.
Brake hose: Replace every four
years.
6-28
EAU03238
Checking and lubricating the
cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the ca-
bles and cable ends should be lubricat-
ed if necessary. If a cable is damaged
or does not move smoothly, have a
Yamaha dealer check or replace it.
Recommended lubricant:
Engine oil
WARNING
@
Damage to the outer sheath may in-
terfere with proper cable operation
and will cause the inner cable to
rust. Replace a damaged cable as
soon as possible to prevent unsafe
conditions.
@
EAU02962
EW000112
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents