Handlebar Switches - Yamaha VMAX VMX12 Owner's Manual

1. Pass switch " "
2. Dimmer switch
3. Turn signal switch " "
4. Horn switch " "

Handlebar switches

Pass switch " "
Press this switch to flash the headlight.
Dimmer switch
Set this switch to " " for the high
beam and to " " for the low beam.
INSTRUMENT AND CONTROL FUNCTIONS
Turn signal switch "
To signal a right-hand turn, push this
switch to the right. To signal a left-hand
turn, push this switch to the left. When
released, the switch returns to the cen-
ter position.
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the motor-
cycle has traveled both about 150 m
and for approximately 15 seconds.
However, the turn signal lights can also
EAU00118
be canceled manually by pushing the
switch in after it has returned to the
center position.
EAU00119
NOTE:
@
The self-canceling system only oper-
ates when the motorcycle is moving, so
EAU00121
that the turn signal lights will not self-
cancel while you are stopped at an in-
tersection.
@
Horn switch "
Press this switch to sound the horn.
EAU00124
"
1. Engine stop switch
2. Light switch
3. Start switch "
4. Fuel reserve switch "FUEL"
Engine stop switch
Set this switch to "
gine in case of an emergency, such as
when the motorcycle overturns or
when the throttle cable is stuck.
Light switch
Set this switch to "
auxiliary light, meter lighting and tail-
light. Set the switch to "
the headlight also.
EAU00129
"
3-4
"
EAU00138
" to stop the en-
EAU00134
" to turn on the
" to turn on
3