PERIODIC MAINTENANCE AND ADJUSTMENT
1. Locknut
2. Drive chain slack adjusting bolt
3. Axle nut
5. While supporting the brake caliper
and slightly lifting the wheel, pull
the wheel axle out.
6
1. Locknut
2. Drive chain slack adjusting bolt
3. Wheel axle
4. Brake caliper bracket
5. Brake caliper
TIP
A rubber mallet may be useful to tap the
wheel axle out.
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
6-38
TIP
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
7. Remove the wheel. NOTICE: Do
not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
erwise the brake pads will be
forced shut.
[ECA11071]
To install the rear wheel
1. Install the wheel and the brake cal-
iper bracket by inserting the wheel
axle from the right-hand side.
EAU32943