Shifting - Yamaha FZ6-NHG Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS
serve the battery. Do not crank the en-
gine more than 10 seconds on any one
attempt.
CAUTION:
G If the oil level warning light flick-
ers or remains on after starting,
immediately stop the engine,
and then check the engine oil
level and the vehicle for oil leak-
age. If necessary, add engine
oil, and then check the warning
5
light again.
G If the coolant temperature warn-
ing light flickers or remains on
after starting, immediately stop
the engine, and then check the
coolant level and the vehicle for
coolant leakage. If necessary,
add coolant, and then check the
warning light again.
G
If the engine trouble warning
light flashes or remains on after
starting, immediately stop the
engine, and have a Yamaha
dealer check the cause.
G
For ABS model only
If the ABS warning light flashes
or remains on after starting, the
ABS may be defective, and the
ECA16040
brake system reverts to conven-
tional braking.
If this occurs, have a Yamaha
dealer check the system as
soon as possible.
G The immobilizer system indica-
tor light should come on when
the key is turned to "ON", and
then go off after a few seconds.
If the indicator light does not
come on, or does not go off, or
if it flashes and the display indi-
cates a two-digit error code,
have a Yamaha dealer check the
electrical circuit.
CAUTION:
For maximum engine life, never ac-
celerate hard when the engine is
cold!

Shifting

1. Shift pedal
2. Neutral position
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
ECA11040
NOTE:
To shift the transmission into the neu-
tral position, press the shift pedal down
repeatedly until it reaches the end of its
travel, and then slightly raise it.
5-2
EAU16671