Shifting - Yamaha R7 2024 Owner's Manual

Shifting

6
5
4
1 1 1 3
2
N
1
2
1. Gear positions
2. Shift pedal
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position ( ), press the shift pedal
down repeatedly until it reaches the
end of its travel, and then slightly raise
it.
Operation and important riding points
EAU16675
NOTICE
 When shifting, press the shift
pedal firmly until you feel the
gear shift is complete.
 Even with the transmission in
the neutral position, do not
coast for long periods of time
with the engine off, nor tow the
motorcycle for long distances.
The transmission is properly lu-
bricated only when the engine is
running. Inadequate lubrication
may damage the transmission.
 Always use the clutch while
changing gears to avoid dam-
aging the engine, transmission,
and drive train, which are not
designed to
shock of forced shifting.
To start out and accelerate
1. Pull the clutch lever to disengage
the clutch.
2. Shift the transmission into first
gear. The neutral indicator light
should go out.
3. Open the throttle gradually, and at
ECA10262
4. At the recommended shift points
5. Shift the transmission into second
6. Open the throttle part way and
7. Follow the same procedure when
TIP
When shifting gears in normal operat-
ing conditions, use the recommended
withstand the
shift points.
To decelerate
EAU16682
1. Release the throttle and apply
2. At the recommended shift points
6-3
the same time, release the clutch
lever slowly.
shown in the following table, close
the throttle, and at the same time,
quickly pull the clutch lever in.
gear. (Make sure not to shift the
transmission into the neutral posi-
tion.)
gradually release the clutch lever.
shifting to the next higher gear.
both the front and the rear brakes
smoothly to slow the motorcycle.
shown in the following table, shift
to a lower gear.
6
EAU58270