How To Run A Wash Cycle; Daily Use - Electrolux EWT 136551 W User Manual

Electrolux washing machine
Table of Contents

Advertisement

4 electrolux
Use
• Your appliance is intended for normal do-
mestic use. Do not use the appliance for
commercial or industrial purposes or for
any other purpose.
• Refer to the instructions on the label of
each item before washing.
• Do not put items into the washing ma-
chine which have had stains removed
with petrol, alcohol, trichlorethylen etc. If
such stain removers have been used,
wait until the product has evaporated be-
fore putting these items into the drum.
PERSONALISATION
Child safety
This option provides two types of locking :
• if the option is activated after the cycle
has started, no changes to the options or
programme is possible.
The cycle runs and you must deactivate
the option to run a new cycle.
• if the option is activated before the cycle
has started, the appliance cannot be
started.
To activate child safety, turn appliance on
and press "Rinse plus"
simultaneously until the confirmation
symbol
shows on in the display. The ap-

HOW TO RUN A WASH CYCLE?

Using for the first time
• Ensure the electrical and water con-
nections comply with the installation
instructions.
• Remove the polystyrene insert and
all other items inside the drum.

DAILY USE

Loading washing
A
• Open the lid of the appliance.
1) Depending on model.
and "Delay start"
A
• Empty pockets and unfold items.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge, un-
less they have been given supervision or
instruction concerning use of the appli-
ance by a person responsible for their
safety.
Children should be supervised to ensure
that they do not play with the appliance.
pliance memorises the selection of this op-
tion. To deactivate child safety, repeat the
process.
Audible signal
When the audible signal is activated, it
sounds when a button is pressed, at the
end of the programme, to indicate a fault.
To deactivate, turn appliance on and press
"Prewash"
and "Rinse plus"
neously until the beep sounds. The signal is
only active if alarm sounds. To reactivate it,
repeat the same process.
• Run an initial wash cycle at 90°C,
without any washing but with deter-
gent to clean the water tank.
• Open the drum by depressing the locking
1)
button A
: The two shutters unlock au-
tomatically.
• Load the washing, close the drum and
the lid of your washing machine.
Warning! Before closing the lid of your
appliance, ensure that the drum is
properly closed :
• When the two shutters are closed,
• locking button A released.
simulta-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents