GA-3PXSL-RH Motherboard
2nd LAN Controller
Auto
Disabled
IDE HDD Block Mode
The IDE HDD Block Mode feature speeds up hard disk access by transferring data from
multiple sectors at once instead of using the old single sector transfer mode. When you enable
it, the BIOS will automatically detect if your hard disk supports block transfers and configure the
proper block transfer settings for it. Up to 64KB of data can be transferred per interrupt with IDE
HDD Block Mode enabled.
Enabled
Disabled
Onboard FDC Controller
Enabled
Disabled
Onboard Serial Port 1
Auto BIOS will automatically setup the port 1 address.
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Onboard Serial Port 2
Auto BIOS will automatically setup the port 2 address.
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Auto detect onboard second H/W LAN. (Default value)
Disable this function.
Enable IDE HDD Block Mode. (Default value)
Disable this function.
Select "enabled" to active Onboard Floppy Controller. (Default value)
Disable this function.
Enable onboard Serial port 1 and set IO address to 3F8. (Default value)
Enable onboard Serial port 1 and set IO address to 2F8.
Enable onboard Serial port 1 and set IO address to 3E8.
Enable onboard Serial port 1 and set IO address to 2E8.
Disable onboard Serial port 1.
Enable onboard Serial port 2 and set IO address to 3F8.
Enable onboard Serial port 2 and set IO address to 2F8. (Default value)
Enable onboard Serial port 2 and set IO address to 3E8.
Enable onboard Serial port 2 and set IO address to 2E8.
Disable onboard Serial port 2.
4 4