Table of Contents
Advertisement
Onboard Serial Port 2
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Onboard Parallel Port
Disabled
378/IRQ7
278/IRQ5
3BC/IRQ7
Parallel Port Mode
SPP
EPP
ECP
ECP+EPP
ECP Mode Use DMA
3
1
On-Chip USB
Disabled
V1.1+V2.0
V1.1
Legacy USB Keyboard/Storage
Enabled
Disabled
Legacy (DOS) USB Mouse
Enabled
Disabled
Legacy USB Storage detect
Enabled
Disabled
GA-K8NE-RH Motherboard
BIOS will automatically set up the Serial port 2 address.
Enable onboard Serial port 2 and address is 3F8/IRQ4.
Enable onboard Serial port 2 and address is 2F8/IRQ3. (Default value)
Enable onboard Serial port 2 and address is 3E8/IRQ4.
Enable onboard Serial port 2 and address is 2E8/IRQ3.
Disable onboard Serial port 2.
Disable onboard LPT port.
Enable onboard LPT port and address is 378/IRQ7. (Default value)
Enable onboard LPT port and address is 278/IRQ5.
Enable onboard LPT port and address is 3BC/IRQ7.
Using Parallel port as Standard Parallel Port. (Default value)
Using Parallel port as Enhanced Parallel Port.
Using Parallel port as Extended Capabilities Port.
Using Parallel port as ECP and EPP mode.
Set ECP Mode Use DMA to 3. (Default value)
Set ECP Mode Use DMA to 1.
Disable this function if you are not using onboard USB function.
Enable USB 1.1 and USB 2.0 controller. (Default value)
Enable only USB 1.1 controller.
Enable USB keyboard support in the MS-DOS environment.
Disable this function. (Default value)
Enable USB mouse support in the MS-DOS environment.
Disable this function. (Default value)
Enable USB storage detect function. (Default value)
Disable this function.
- 36 -
Advertisement
Table of Contents
