Technical Information - BLUE SKY EXO User Manual

This next section outlines the components, specifications and
performance data that make this product such a uniquely high
value.
In order to continually improve all of its products, Blue Sky reserves
the right to change these specifications without notice.
eXo Specifications
General Specifications
XLR / TRS Combo
60k Ohms balanced
200k Ohms balanced
RCA input:
30k Ohms unbalanced
3.5mm (front panel input)
15k Ohms unbalanced
Common Mode Rejection Ratio
40 dB typical @ 60Hz
Maximum Input Level
+18 dBu XLR / TRS/ RCA
+30 dBu XLR / TRS
+12 dBu 3.5mm / Mini-Jack (front panel input)
Voltage Sensitivity
200mV = 90 dB SPL @ 1m XLR/TRS
200mV = 90 dB SPL @ 1m RCA
200mV = 96 dB SPL @ 1m 3.5mm
Note: 200mV = -11.75 dBu = -14 dBV
Amplifier power output Note: All power output measurements
made with the speaker protection circuits disabled. Long term
power output is limited by the speaker protection circuitry.
Short term power output 1 channel driven:
42 watts x 1 @ <.1% THD into 4 ohms @ 1 kHz
Short term power output 2 channels driven :
35 watts x 2 @ <.1% THD into 4 ohms @ 1 kHz
Subwoofer power output:
90 watts x 1 @ <1% THD into 4 ohms @ 50 HZ
3.5mm headphone output:
4 mW x 2 @ <.2% THD into 16 ohms @ 1 kHz
Mains voltages:
115V / 60Hz (North American Version)
230V / 50Hz (Export)
Voltage is set at the factory
Maximum power consumption:
240 watts
Fuse Type and Rating:
115V = 5 x 20mm, T 2 Amp 250V
230V = 5 x 20mm, T 1 Amp 250V
Stereo Monitoring System
USER MANUAL • 10 • Technical Information
Input gain = +0dBu
Input gain = -12 dBu
(balanced inputs only)
Input gain = +0dBu
Input gain = -12dBu
(input gain = 0dBu)
(front panel input)
.
(Time Delay)
(Time Delay)
Satellite
• The single 1/4" X 20 insert on the back of the eXo SAT
is compatible with BT Technologies BT-33 Brackets (www.btech-
usa.com) and is also compatible with OmniMount's type 10 Series
of wall / ceiling brackets (www.omnimount.com). For more details
on this mounting insert please see page 12 [Satellite Cabinet
Dimensions]
• Dimensions:
8" H X 5" D x 5" W
20.3 cm X 12.7 cm x 12.7 cm
• Weight 3 lbs. / 1.36 kg
• 3" cast frame woofer, hemispherical anodized
aluminium cone, Neodymium motor structure
• 1" fabric Neodymium tweeter
• Fully Video Shielded
• Satellite Low frequency crossover
• Tweeter Crossover Frequency
• Nominal SAT impedance
The following specifications are measured using the eXo Amplifier
• Frequency Response Satellite
8" Sealed Box Subwoofer
• 8" woofer, vented motor, paper cone with foam surround
• Fully video shielded,
• Isolation feet are included
• Inserts for optional attachment of spiked feet
• Dimensions:
(subwoofer only)
12" H x 12" W x 13" D
30.5 cm x 30.5 cm x 33 cm
(subwoofer with isolation feet)
13.8" H x 12" W x 13" D
33 cm x 30.5 cm x 33 cm
• Weight 25 lbs. / 11.4kg
• Frequency Response Subwoofer
Anechoic Response:
35 to 140Hz +/-6dB
Typical In-Room Response:
20 to 200Hz (1500 Cubic Feet)
User Manual • Technical Information • Page 11
140 Hz
2200 Hz
4 Ohms
+/- 2.0dB 200 to 10 kHz
+/- 3.0dB 140 to 20 kHz