Vais Technology SL2Vi Owner's Manual page 16

Force Program
Force 3 Mode programming steps:
!
Put switches in appropriate position (CD or MD) for programming according to application guide.
!
Put ignition switch to "ACC" position.
!
Wait for long beep followed by a few short beeps. This may take up to one minute.
!
Put "Both" programming switches in "UP" position, wait for long beep (can take up to 30 seconds)
!
Put "Right" programming switch in "DOWN" position, wait for beep.
!
Put "Left" programming switch in "DOWN" position, wait for beep.
!
Put "Left" programming switch in "UP" position, no beep.
!
Put "Left" programming switch in "DOWN" position, wait for beep.
!
Put "Left" programming switch in "UP" position, no beep.
!
Put "Left" programming switch in "DOWN" position, wait for beep.
!
Put "Left" programming switch in "UP" position, no beep.
!
Put "Right" programming switch in "UP" position, wait for long beep.
!
Put ignition switch to "OFF" position
!
Wait at least 10 seconds
!
Put ignition switch into "ACC" or "ON" position.
Emulation Mode Selection
Ignition into
Choose
"ACC" or "ON"
proper
position
emulation
mode
(see Installation)
Force 3 Mode Program
Both switches
Wait up to 30 sec
"UP" confirmation beep
Wait for short beep
Right switch Right switch
stays "DOWN" stays "DOWN"
Left switch Left switch
"UP" "DOWN"
Wait for short beep
Right switch Right switch
stays "DOWN" stays "DOWN"
Left switch Left switch
"UP" "DOWN"
Wait for short beep
Right switch Right switch
stays "DOWN" stays "DOWN"
Left switch Left switch
"UP" "DOWN"
Wait for long beep
Both switches
"OFF" position
"UP"
Right
Wait for short beep
switch
Long
"DOWN"
Wait 10 sec
Ignition into
16
Wait for short beep
Right switch
stays "DOWN"
Left switch
"DOWN"