Vais Technology SL2Vi Owner's Manual page 14

Installation
CD-MP3 Emulation Mode Selection (CD-MP3 emulation)
CD-MP3 Emulation Mode programming steps:
!
Properly install this unit.
!
Put "Left" programming switch in "DOWN" position.
!
Put ignition switch into the "ACC" position.
!
Wait for long beep followed by a few short beeps. This may take up to one minute.
!
Return programming switches into their default position (both switches "UP").
Wait up to 30 seconds until confirmation beep.
!
Put ignition switch into the "OFF" position. Wait at least 10 seconds.
!
Put ignition switch into "ACC" position.
!
Check SoundLinQ2 for functionality, especially TEXT capabilities.
Ignition into
Left "ACC" or "ON"
switch position
"DOWN"
Mounting unit using Velcro fasteners
NOTE
!
Velcro Fasteners are not included
!
VAIS Technology strongly recomand to ground unit to the car chassis for best results
!
Do not more the 5mm size screws. Using screws larger then 5mm may damage the PCB board.
Both
switches
up to 30 sec
"UP"
SoundLinQ2
M4 x 5mm*
(see note below)
"Hard" Velcro Fastener
"Soft" Velcro Fastener
Carpet or car chassis
14
Ignition into
"OFF" position
Confirmation beep