Something Not Working - Electrolux ERE3600 Instruction Booklet

Something Not Working

Before contacting your local Service Force Centre check the following point:
Problem
" " is displayed in the temperature
display.
Audible alarm + flashing red warning
lamp. (It is too warm inside the freezer.)
It is too warm inside the refrigerator.
It is too cold inside the refrigerator.
It is for cold in the "Natura-fresh" zone.
Water comes out on the floor.
It is too warm inside the freezer.
It is too cold inside the freezer.
Too much frost and ice are produced.
The compressor operates continuously.
Possible cause / Remedy
An error has occurred in measuring the temperature. Call your
service representative. (The cooling system will continue to
keep food products cold, but temperature adjustment will not
be possible.)
Switch off the audible alarm by pressing the alarm off button.
The audible alarm could have been triggered by:
The cabinet having been recently switched on and the
temperature still being too high. See the chapter "Switching on
and setting the temperature".
The door may have been open for so long that the `door open'
alarm was triggered.
Set a lower temperature.
Put food products in the right place inside the refrigerator. See
the chapter "Temperature inside the refrigerator".
Distribute the food products to allow cold air to circulate
around them.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Set a warmer temperature.
Push the "-" and the "reset" buttons simultaneously about 5
seconds.
Place the drain hose at the back of the cabinet above the drain
bowl. See the chapter "Before using the cabinet the first time".
Set a lower temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
Set a warmer temperature.
Action Freeze could have been switched on.
The temperature display shows the highest temperature inside
the cabinet. Thus a difference between the temperature
indicated on the display and the (average) temperature
measured in another way is normal.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
77
GB
Electrolux 818 34 37-05/5