ActionTec GT724WG User Manual page 13

Windows 2000:
1. Select Start, then Settings, and then Control Panel.
2. Select Network and Dialup Connections.
3. Right-click Local Area Connection, then select Properties.
4. Highlight (do not uncheck) Internet Protocol TCP/IP.
5. Select Properties.
6. Set the computer to Use the following IP Address.
7. Use the information from your welcome letter to complete the configuration fields (IP Address, Subnet Mask,
Default Gateway, DNS).
Mac OS X:
1. Select the Apple menu, then select System Preferences.
2. Select Network.
3. On the Show dropdown box, select Built-In Ethernet.
4. On the TCP/IP tab,make certain the Configure IPv4 dropdown box is set to Manually.
5. Using the information from your welcome letter, set the following:
• IP Address:
• Subnet Mask:
• Default Gateway:
• DNS Servers:
6. When asked if you want to apply configuration changes, select Apply.
Mac OS 8/9:
1. Select the Apple menu, then select Control Panels, and select TCP/IP.
2. On the Connect via dropdown box, select Ethernet.
3. On the Configure dropdown box, select Manually.
4. Using the information from your welcome letter, set the following:
• IP Address:
• Subnet Mask:
• Router Address:
• Name Server Addr.:
5. Click Close.
6. When asked if you want to save changes to the configuration, select Save.
After configuring your computer, reboot your router by turning it off and then back on. Finally, open a browser
and verify that you can access the Internet. If you cannot, please contact our Internet Technical Support team.
1-888-850-5915
Technical Support
Actiontec GT724WG Router
One of the LAN Usable IPs
LAN Subnet Mask
LAN Default Gateway
DNS Primary & Secondary Servers
Any one of the LAN Usable IPs
LAN Subnet Mask
LAN Default Gateway.
DNS Primary & Secondary Servers
Setup and User Guide
12
103948/3-11/6960