Pnp/Pci Configurations; Pnp Os Installed [No]; Reset Configuration Date [Disabled]; Resources Controlled By [Auto(Escd)] - Asus P5VDC-TVM SE User Manual

2.8

PnP/PCI Configurations

The PnP/PCI Configurations menu items allow you to change the settings for
PnP/PCI devices.
PNP OS Installed
Reset Configuration Data
Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
** PCI Express relative items **
Maximum Payload Size
: Move
F5: Previous Values
2.8.1

PNP OS Installed [No]

When set to [No], the BIOS configures all the devices in the system. When set to
[Yes] and If you install a Plug and Play operating system, the operating system
configures the Plug and Play devices not required for boot.
Configuration options: [No] [Yes]
2.8.2 Reset Configuration Data [Disabled]
If you installed an add-on device and the system reconfiguration caused a serious
conflict such that the system cannot boot, set this item to [Enabled] to reset
Extended System Configuration Data (ESCD) when you exit Setup.
Configuration options: [Disabled] [Enabled]
2.8.3

Resources Controlled By [Auto(ESCD)]

Setting to [Auto] allows the BIOS to automatically configure all the boot and
compatible Plug and Play devices. You cannot confgure the IRQ DMA and memory
base address fields if you set to [Auto] because the BIOS automatically assigns
them. Configuration options: [Auto(ESCD)] [Manual]
2-20
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
[No]
[Disabled]
[Auto(ESCD)]
[Disabled]
[Enabled]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[4096]
Enter:Select +/-/PU/PD:Value
F6: Fail-Safe Defaults
Press Enter
F10:Save&Exit
Select Menu
Item Specific Help
Select Yes if you are
using a Plug and Play
capable operating
system. Select No if
you need the BIOS to
configure non-boot
devices
ESC:Exit F1:General Help
F9: Optimized Defaults
Chapter 2: BIOS setup